Okidata 320 manual code#

If the printer has a paper jam or pushing FF/LOAD does not eject the paper, be sure to TURN OFF the printer before attempting to remove the paper. If the paper loads crookedly or does not reach the red line, press FF/LOAD to eject the paper, then try again to reload the paper. When first loading a pre-printed form into the Okidata ML 320 Turbo, be sure that the form loads in straight and that the top of the form is even with the red line on the clear plastic piece, or sometimes even up to 1/8' above it. Please call Frazer at 1-88 to obtain the correct version of the form.

Okidata 320 manual code#

If either the Code or Version do not match what is printed on the contract, the form may not align properly in places. If everything checks out OR you're using an Epson printer and the forms are still not lining up, give Frazer's tech support a call at 88. To troubleshoot this try checking out Frazer's Okidata alignment checklist (Okidata only).

Occasionally, even with the right settings, things just aren't lining up. Once complete, assuming both the form code and version match on both your physical form and what's listed in your 'print forms' list in Frazer, the dot matrix printer of your choosing should fill in the form in the appropriate boxes. To print a pre-printed document, confirm that the Form Code and Revision Date on the form itself matches the form selected in the screen. Be sure that a setup of the Okidata printer has been completed.